Carpenter's Guide to HDHMR Boards — Tips for Working with HDHMR

Carpenter's Guide to Working with HDHMR Boards

As Warangal's authorized Action TESA HDHMR dealer, we work closely with hundreds of local carpenters. This guide covers everything you need to know about working with HDHMR boards effectively for the best results.

Cutting HDHMR Boards

• Use a fine-tooth circular saw blade — 60+ teeth recommended for clean cuts
• Cut at moderate speed — don't rush, let the blade do the work
• Support the board properly to prevent chipping at the cut edge
• Score the surface first for very fine finish cuts

Drilling & Screwing into HDHMR

• Pre-drill holes before inserting screws — especially near edges
• Use coarse-thread wood screws for maximum holding power
• Maintain minimum 15mm from edges to prevent splitting
• HDHMR's high density means excellent screw retention once in place

Routing & Edge Profiling HDHMR

• HDHMR's uniform density gives excellent routing results
• Use sharp router bits — replace dull bits immediately
• Multi-pass routing recommended for deep profiles
• Edge banding adheres excellently to HDHMR edges

Laminating HDHMR Boards

• HDHMR's smooth surface is ideal for direct lamination
• No sanding required before applying laminates
• Use quality contact adhesive for best results
• Apply even pressure across the entire surface